Toyota Landcruiser Prado 120 / 150 series ABS Pump Master Cylinder Booster Assembly MN116391 MR977461 MR569728

Common Symptoms & Fault Codes:
Is your vehicle experiencing any of the following issues?
ABS warning light & buzzer activation
Hard brake pedal & pump motor failure
C1251: Hydraulic brake booster pump motor open malfunction
C1252: Hydraulic brake booster pump on time abnormally long
C1256: Accumulator low pressure malfunction
Code 57: Accumulator pressure system malfunction (Mitsubishi)
Cost-Effective Replacement Solution:
We provide a reliable remanufactured ABS pump as an affordable and practical alternative to purchasing an expensive brand-new unit from the dealership

Cost-Effective Replacement Solution:
We provide a reliable remanufactured ABS pump as an affordable and practical alternative to purchasing an expensive brand-new unit.

Product Highlights:
Cost & Time Saving: A highly affordable alternative to purchasing a complete remanufactured unit.
No Programming Required: Guarantees that no programming is required upon refitting of the unit.
Factory Tested: Every unit is carefully tested before shipping to ensure reliable performance.
Ready for Setup: Every unit comes with detailed bleeding instructions to follow during reinstallation.

Specifications:
Condition: Remanufactured
Manufacturer Part Number: MN116391, MR977461, MR569728

Fitment:
For Toyota Landcruiser 100 series
For Toyota Landcruiser Prado 120 / 150 series
For Lexus LX 100 series
For Lexus GS / SC series
For Mitsubishi Pajero NM-NW series
***Not sure? Please message us your VIN or photos of the original part for a fitment check.***

Package included:
1 x ABS Pump

Fast Local Shipping:
Dispatched from: Our Melbourne warehouse
Delivery Time: 2-6 working days delivery across Australia
Shipping Cost: FREE Shipping

Note:
1.Please make sure the part you purchased fit your car before the purchasing. If you can not make sure, please send me message of your VIN , we will help you check.
2.Professional installation is recommended.

Before installing the ABS pump, the tire air must be drained as follows:
1. Install the six oil pipes of the ABS pump and do not install the plugs
2. Do not start the car and apply the brakes three or four times
3. Unscrew the air pump screw on the brake disc, first drain the gas from the left front wheel, and then drain the gas from the right front wheel
4. After exhausting the air, plug in the ABS pump plug
5. Apply the brake three times in a row, hear the sound of the motor turning, and then open the rear wheel exhaust valve. Evacuate the left and right wheels three times each